General Question

Observing members: 0 Composing members: 0

9 Answers

hungryhungryhortence's avatar

Buy some velcro patches and cut them to the shapes you want so you can alter The Face of Doom at will.

kfingerman's avatar

buy a grey hoodie, some black fabric, scissors, needle, and thread…BOOM

augustlan's avatar

I’m going to agree with the above. Pretty sure that thing was altered by the wearer, not manufactured that way.

Buttonstc's avatar

An easier alternative to sewing is to use something like HEAT N BOND or any brand of iron-on stabilizer.

It’s basically a very thin layer of fabric glue sandwiched between two layers of special.

To use it you peel off one layer of paper and iron it to the back of an appropriately sized piece of black fabric. This then heat fuses it to the fabric.

Then cut out the two pieces as in the picture.

Then take off the other paper layer. Lay it on the spot desired on the hood and iron it again. All done.

Sort of similar to soldering except with fabric and glue rather than rather than two pieces of metal.

You can get these products at craft stores and if you go to Joannes they also carry fabric. One stop shopping.

Buttonstc's avatar

Edit: special paper

Dang iPhone grumble grumble

:)

brinibear's avatar

I agree that making it would be a lot easier, to make it, but mabey you could try HotTopic, or mabey if your lucky, Wal-Mart

elijah's avatar

It just looks like crazy eyebrows.

drdoombot's avatar

@bumwithablackberry If they had that in a Dr. Doom face mask variant, I would instantly jizz in my pants.

Answer this question

Login

or

Join

to answer.

This question is in the General Section. Responses must be helpful and on-topic.

Your answer will be saved while you login or join.

Have a question? Ask Fluther!

What do you know more about?
or
Knowledge Networking @ Fluther